Crusher Hammer Maintenance Guide : 5 Core Techniques to Extend Life and Prevent Vibration
Publish:
2025-11-07 08:53
发布人:
清水源
View:
As a high-consumability part, proper maintenance of the hammerhead not only reduces replacement costs but also prevents problems like rotor imbalance and equipment vibration caused by uneven hammerhead wear. Based on industry practice, key maintenance points can be summarized as "1. Check, 2. Turn, 3. Balance, 4. Hoist, 5. Replace."
1. Regular inspection
- Frequency : Check high-load lines daily, and medium and low-load lines once every 2-3 days.
- Key points : If the oil leakage surface is worn more than 60mm, it needs to be treated, and check the displacement of the wedge block or the cracking of the pressure plate welding.
2. Hammer head flip
- Timing: When to grind 60mm on one side, the other side is intact and the hammer head is symmetrical.
- Requirements : All four groups must flip simultaneously to prevent the rotor's center of gravity from shifting.
3. Dynamic balance adjustment
- Trigger : The hammer head has large wear differences, and the vibration during the test run after flipping exceeds 0.15mm.
- Method : Assemble the heavy hammer head (error ≤ 50g) on the symmetrical hammer seat and adjust the vibration to ≤ 0.1mm.
4. Standardized lifting
- Timing : After turning over, grind another 60mm or when one side is severely worn, replace the hammer head as a whole.
- Requirements : 4 groups of synchronous lifting to ensure alignment, use special clamps to avoid direct binding of wire ropes.
5. Auxiliary hammer replacement
- Judgment : When the main hammer head grinds 60mm, the auxiliary hammer head is replaced synchronously.
- Note : Adjust the gap (5-10mm) according to the instructions to prevent excessive particle size or component friction.







